PICK YOUR PLAN FROM OUR ONE YEAR AGREEMENTS ..........
|
$89.00
CHOOSE ONE
* PLUMBING
* HEATING
* AIR CONDITIONING
|
$139.00
CHOOSE TWO
* PLUMBING
* HEATING
* AIR CONDITIONING
|
$189.00
ALL THREE INCLUDED
* PLUMBING
* HEATING
* AIR CONDITIONING
|
OIL HEAT
ADD
$125.00
TO GOLD PLAN FOR
EACH APPLIANCE
INCLUDES:
* NEW NOZZLES
* CLEAN / RESET ELECTRODES
|
ADD
$199.00
EACH APPLIANCE
($299.00 if sold separately)
*TANKLESS WATER HEATER
(CLEAN & FLUSH)
*WATER FILTRATION SYSTEM
(CLEAN & ADD SALT)
|
Plans include: where applicable
| * Each plan includes an 11% discount on ALL parts
and labor while under agreement |
| * 30 point Spring and/or Fall HVAC inspection |
| * Comprehensive Annual plumbing inspection |
Stan Perkoski's Exclusives with ALL plans:
| * Annual Carbon monoxide safety inspection on fuel-burning
heaters, to include water heaters. |
| * Annual water heater anode rod inspection for flood
protection & extended life. |
Tankless Water Heater plan includes:
| * Annual cleaning, which includes flushing the entire
unit to remove any mineral deposits (usually calcium)
that may have built up inside the boilers. We use low-grade
acid that is pumped through the system to clear out
these deposits. |
Our
comprehensive preventative
maintenance plan includes the following check
list
(List varies depending on oil, gas or electric):
- Visually
inspect venting
- Test
for presence of carbon monoxide
- Check
humidifier operation
- Check
thermostat calibration
- Check
nozzles
- Change
small or large oil filter
- Clean
electrodes
- Aligned
electrodes
- Clean
burner box
- Oil
circulator motor or circulators
- Check
water/system pressure
- Check
water/steam pressure gauge
- Drain
expansion tank
- Check
Stack temperature
- Smoke
test
- Clean
coils / blower motor
|
-
Check air filter
- Clean
flame sensor / thermocouple / spark igniter
- Adjust
pilot
- Check
Hot Surface Igniter Resistance Value
- Inspect
Electrical Components
- Check
controls, sensors, draft inducer motor
- Test
safety controls
- Clean
flue pipe and base of flue
- Monitor
flue draft
- Vacuum
heat exchanger and brush burner
- Inspect
heat exchanger for visible cracks
- Check
oil and adjust blower components
- Lubricate
all moving parts where necessary
- Check
drainage (Condensing 90% furnace only)
- Measure
temperature difference supply / return
- Check
refrigerant levelsrenc
|
With 99% of our jobs completed the same day, Stan Perkoski's
Home Services, Inc. is your clear choice when
dealing with your home comfort needs! One call does it all!
